Fórum - Téma


Self-diagnostic ETM - zkoušel to někdo?


Fórum Technický koutek Self-diagnostic ETM - zkoušel to někdo?




2013-03-05 13:55:56

Má to fungovat pro X-type a S-type, ale mohlo by to fungovat i pro XJ, to s S-typem dost sdílí co se týče palubovky atd.

Hidden away in the X Type and S Type is a very useful Integrated Diagnostic System (IDS).

This IDS is a self-diagnostic mode known as ETM, it can be used to show the status of the instrument cluster inputs as well as other useful diagnostic features. The central LCD on the X Type and RH Message center S-Type displays internal data that can be cycled through by repeated pressing the trip button.

S-TYPE Instrument Cluster Self-Diagnostic ETM

To place the cluster in ETM, perform the following:

Press and hold the stalk trip cycle button whilst turning the ignition from position 0 to position II, until 'ENGINEERING TEST MODE’ is displayed on the RH Message Centre display. The stalk trip cycle button must be released within three seconds of 'ENGINEERING TEST MODE’ being displayed or the instrument cluster will exit Self- Diagnostic mode.

To navigate forward through the instrument cluster Self-Diagnostic Mode tests, press the trip computer ‘MLS/KMS’ button.

To navigate backward through the instrument cluster Self-Diagnostic Mode tests, press the trip computer ‘A/B’ button.

To exit Self-Diagnostic Mode, press the stalk trip cycle button for more than three seconds.

The Self-Diagnostic Mode is also deactivated when the ignition switch is turned to the 'OFF' position, or low battery voltage is detected.

If the Self-Diagnostic Mode cannot be accessed (check function of buttons), use IDS/WDS to diagnose the instrument cluster.

2013-03-08 14:24:30

Zkusím to...Díky

2013-03-31 15:50:45

vita39: Zkousel sem to, funguje je to.


Odpovědět